APC BX700U-MS Back-UPS 700VA, 230V, AVR, Universal and IEC Sockets

Data sheet

UPS Type	Back-UPS
Rack Mountable	No
UPS Orientation	Tower
Power Rated VA	700

More info

APC BX700U-MS Back-UPS 700VA, 230V, AVR, Universal and IEC Sockets
Model: BX700U-MS

Output

Output power capacity
390Watts / 700VA
Max Configurable Power (Watts)
390Watts / 700VA
Nominal Output Voltage
230V
Output Frequency (sync to mains)
50/60 Hz +/-1 Hz
Output Frequency (not synced)
50/60 Hz +/-1 Hz
Topology
Line Interactive
Waveform type
Stepped approximation to a sinewave
Output Connections

(1) IEC 320 C13 (Battery Backup)
Transfer Time
4ms typical : 6ms maximum

Input

Nominal Input Voltage
230V
Input frequency
50/60 Hz +/- 3 Hz (auto sensing)
Input Connections
IEC-320 C14, NEMA 5-15P
Cord Length
1.22meters
Input voltage range for main operations
140 - 300V
Number of Power Cords
2
Type of Input Protection Required
3-pole breaker

Batteries & Runtime

Battery type
Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time
6hour(s)
Replacement Battery
APCRBC110
Expected Battery Life (years)
2 - 5
Battery Volt-Amp-Hour Capacity
81

Communications & Management

Interface Port(s)
USB
Control panel
LED status display with load and battery bar-graphs and On Line : On Battery : Replace Battery : and Overload Indicators
Audible Alarm
Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm

Surge Protection and Filtering

Surge energy rating
273Joules
Data Line Protection
RJ-11 Modem/Fax protection

Physical

Maximum Height
200mm , 20.0cm
Maximum Width
115mm , 11.5cm
Maximum Depth
256mm , 25.6cm
Net Weight
6.0kg
Shipping weight
6.8kg
Shipping Height
275mm , 27.5cm
Shipping Width
295mm , 29.5cm
Shipping Depth
340mm , 34.0cm
Color
Black
Master Carton Units
2.0
Master Carton Weight
13.7

Environmental

Operating Environment
0 - 40 °C
Operating Relative Humidity
0 - 95 %
Operating Elevation
0-3000meters
Storage Temperature
-15 - 40 °C
Storage Relative Humidity
0 - 95 %
Storage Elevation
0-9000meters
Audible noise at 1 meter from surface of unit
45.0dBA

Conformance

Standard warranty
2 years repair or replace

Ask a question

NO registration required!

6 Question(s) answered

If the question you have has not yet been answered here, use the form below to ask something about this addon.

Asked by a guest
on 11/11/2020 For APC BX700U-MS Back-UPS 700VA, 230V, AVR, Universal and IEC Sockets Model: BX700U-MS and APC BK500EI Back-UPS CS 500 USB Serial Model: BK500EI, are the battery external or in built battery? Can both sustain for 30mins ? Answer:
For both model, Battery are in build. At full load, the UPS can only sustain 7min to 10mins Thank you
Asked by a guest
on 13/07/2021 Is this product able to communicate with a NAS (Synology 920+) for auto-shutdown in the event of a power failure? Answer:
This is a basic backup UPS thus doesn't have feature to control other device
Asked by Yong Fook lim
on 21/11/2021 (1) What is the differences between BVX700LUI-MS with BX700U-MS (2) is their application suitable for basic NAS with two hard disks? Regards Answer:
Both unit serve the same purpose. BV series have abit more feature build in that all. For your application, you can use both model. Thank you
Asked by Yong Fook lim
on 28/11/2021 Hi I own a synology NAS DS220j with two hard disks. I intend to buy a APC UPS to provide power surge protection and auto command the NAS to shutdown during power failure. Can u suggest what APC UPS model should I purchase. Regards Answer:
To control external device for shutdown procedure, you need a smart UPS. BX700U-MS is a backup UPS for back up power only
Asked by Yong Fook lim
on 28/11/2021 Hi Can APC UPS BVX 700VA interact with synology DS220j to command auto shut down when power is down? Regards Answer:
No likely. For more info, you need to check with APC service center for clarification.
Asked by Yong Fook lim
on 29/11/2021 Thanks for clarification. As for UPS interacting with NAS for auto shut down, I found another UPS APC Back-UPS 700 (part no: BX700U-MS) where it’s backend picture reveals a port indicating “Powerchute USB port”. Does it mean that it can interface with NAS for auto power shut down? Regards Answer:
BX700U-MS does have a powerchute USB port to work with external PC for configuration. APC didn't indicate what software feature it have thus may not have the feature you need. Also, we believe this model isn't in the compatible list of device for your NAS, thus there is a good chance your device cannot communicate with this UPS. Alternatively, this device may work but need some configuration on both machine. Not the plug and play type. Hope the above information help. Please contact APC service center for clarification.

Reviews

Be the first to write a review!